Installation Instructions

Setting Posts

Installing Fence Panel

1. Measure the distance between posts. If necessary,

use a hack saw to cut Top,Mid and Bottom Rails

(F) to fit. Be sure to cut equally from either end.

Fig 2. Setting Posts

2. Use screws (D) to fasten Rail Bracket (C) to

Top,Mid & Bottom Rails (F). (See Fig 3.)

3. Position the fence assembly between the posts.

Align with adjacent fence panels or with the Top

Rail slightly below the top of the vinyl posts.

Screw all Rail Brackets (C) to the Vinyl Posts (

using Screws (D). (See Fig 4.)

4. Affix the Post Cap (B) using PVC glue.

NOTE: This fence type is designed to be installed level

between posts - it does not angle to follow slopes.

1. Dig or auger post holes. The 4" x 5" Vinyl Posts

require a 10" DIAMETER HOLE, and must be at least

30" BELOW GRADE. (See Fig 2.)

In frost regions, the post holes should be deep

enough to extend below the frost line.

2. Mix concrete according to manufacturer's

specifications. Fill the bottom of the hole

to a level 24" from the surface.

3. Set the post into the hole, be sure it is

square

and in-line with your string layout.

4. Pour concrete around the post approximately

6" at a time. Tamp to eliminate air pockets, and

continually check for level.

5. Before the concrete sets, sight down the fence

line to be sure all posts align, and are at the same

height. High posts can be driven deeper by placing a

wooden block across the top and tapping down with

a hammer. Allow concrete to set 24-48 hours.

Use of this product must be in accordance with all local & zoning and/or building codes.

Consumer assumes all risks and liability associated with the use of this product.

For warranty details see the express written limited warranty for your product.

24"

10"

Minimum

30"