Installation Guide

1 2
3
1.Please confirm the three holes on the basin are through holes
as shown from the instructions before install.First,remove all
fixing sets from the fixed group,and then put the body through
the hole on the basin,assemble all fixing sets to the body.
2.Use hand to screw up the locknut,then use install tool
for fixing strengthen.And then connect the outlet hose as
shown.
3.Connect the inlet hose as shown, take note of the "Red"
& "Blue" index from the handle,"Red" for connecting to
the valve for supply hot water, and "Blue" for connecting
to the valve for supply cold water.
1
5
2
3
Hose
4
5
Pop-up
4
4.Install the pop-up.
Disassemble Pop-Up
Firmly hand tighten nut
Connect to Drain
Push to activate
Drain
100 100
3- 9-Ø2 Ø32Max
Hot water
Valve
Cold water
Valve