Specifications

3 Electrical Installation
YASKAWA Europe TOEP C710616 88A - AC Drive A1000 IP23/54 Floor Standing - Quick Start Guide EN 19
 Control Circuit Terminals
The figure below shows the control circuit terminal arrangement. The drive is equipped with screwless terminals.
There are four switches and two jumpers, S1 to S6, located on the terminal board.
S1
<1> The slide switch S6 is available with terminal board “ETC74031”.
Terminal A2 Signal Selection
S2 RS422/485 Termination Resistor
S3
Safe Disable Input
Sink/Source/External Supply Selection
S4 Terminal A3 Analog/PTC Input Selection
S5 Terminal FM/AM Signal Selection
S6 <1> Terminal DM+, DM- (N.C./N.O.) Selection
MA MB MC
M1 M2 M5
M3 M6 M4
E(G) HC H1 H2 DM+ DM- IG R+ R- S+ S-
S1 S2 S3 S4 S5 S6 S7 S8 SN SC SP
V+ AC V- A1 A2 A3 FM AM AC MP RP AC
Use a straight-edge screwdriver
with a blade width of max 2.5 mm
and a thickness of max 0.6 mm to
release the terminals
S2
S3
S1
S4
S5
V
I
V
I
Current Voltage
Off
On
Source Sink
External 24 Vdc
Power Supply
A
nalog Input PTC Input
PTC
AI
PTC
AI
AM
FM
V
I
V
I
AM
FM
FM/AM: Voltage Output FM: Current Output
AM: Voltage Output
N.C.
N.O.