User`s manual

5 FUNCTIONS

From the Drive to PLC

Remote Register Name Description

Monitor data

Stores the monitor data corresponding to the monitor code of RW

While the monitor request flag (RYC) is turned ON, this data are

updated and the monitoring signal (RXC) is turned ON.

Output

frequency

The current output frequency is always set. However, the unit depends

on the setting of o1-03 (frequency reference setting/display unit

selection).

For example, when o1-03 is set to 0, units appear in Hz. When o1-03 is

set to 4, r/min is used.

The value of motor actual rotation speed (units: r/min) is stored at

operation with PG.

At this time, RXB is turned ON. Turning ON RYB, the value of RW

indicates output frequency.

Response code

"00h" is set when the command code and write-in data are correct. If

any of them is incorrect, "01h" to "03h" is set.

Read data Data corresponding to the command code is set.

List of RW

Data Contents for Each Setting of o1-03

o1-03 (Frequency reference

setting/display unit selection)

Data Contents of RW

(operation frequency) data

Output frequency: 0.01Hz (less than 100Hz)

0.1Hz (100Hz or more)

0.01%

Output frequency (E1-04) is 100%.

2 to 39 (number of motor poles) Motor rotational speed (1 r/min)

40 to 39999 User Setting

Note: For more information, refer to the drive instruction manual.