User`s manual

10-12
10
H4-04 Monitor selection (terminal AM) 3
H4-05 Gain (terminal AM) 50.0%
H4-06 Bias (terminal AM) 0.0%
H4-07 Analog output 1 signal level selection 0
H4-08 Analog output 2 signal level selection 0
H5-01 Station address 1F
H5-02 Communications speed selection 3
H5-03 Communications parity selection 0
H5-04 Stopping method after communications error 3
H5-05 Communications error detection selection 1
H5-06 Send wait time 5 ms
H5-07 RTS control ON/OFF 1
H6-01 Pulse train input function selection 0
H6-02 Pulse train input scaling 1440 Hz
H6-03 Pulse train input gain 100.0%
H6-04 Pulse train input bias 0.0%
H6-05 Pulse train input filter time 0.10 s
H6-06 Pulse train monitor selection 2
H6-07 Pulse train monitor scaling 1440 Hz
L1-01 Motor protection selection 1
L1-02 Motor protection time constant 1.0 min
L1-03 Alarm operation selection during motor overheating 3
L1-04 Motor overheating operation selection 1
L1-05 Motor temperature input filter time constant 0.20 s
L2-01 Momentary power loss detection 0
L2-02 Momentary power loss ride through time *1
L2-03 Min. baseblock time *1
L2-04 Voltage recovery time *1
L2-05 Undervoltage detection level *1
L2-06 KEB deceleration time 0.0 s
L2-07 Momentary recovery time *1
L2-08 Frequency reduction gain at KEB start 100%
L3-01 Stall prevention selection during accel 1
L3-02 Stall prevention level during accel 150%
L3-03 Stall prevention limit during accel 50%
L3-04 Stall prevention selection during decel 1
L3-05 Stall prevention selection during running 1
L3-06 Stall prevention level during running 150%
L4-01 Speed agreement detection level 0.0 Hz
L4-02 Speed agreement detection width 2.0 Hz
L4-03 Speed agreement detection level (+/-) 0.0 Hz
L4-04 Speed agreement detection width (+/-) 2.0 Hz
L4-05 Operation when frequency reference is missing 0
L4-06 Frequency reference value at frequency reference loss 80%
L5-01 Number of auto restart attempts 0
No. Name
Factory
Setting
Setting