Instruction manual

3. Mounting

• The same space is required horizontally and vertically and

right and left for both Open Chassis (IP00, IP20) and

Enclosed Wall-mounted (NEMA 1) Inverters.

• Always remove the top and bottom covers before install-

ing a 200 or 400 V Class Inverter with an output of 5.5/7.5

kW in a panel.

 Mounting/Removing Components

Removing and Mounting the Digital Operator and Covers

 Removing the Front Cover

Use a screwdriver to loosen the screw

on the front cover and then remove it

in direction 1. Then press the right

and left sides in direction 2 and lift the

front cover in direction 3.

 Mounting the Front Cover

Mount the front cover by reversing

the order of the above procedure for

removal.

 Removing the Terminal Cover

• Inverters with Width of 108 mm,

140 mm or 170 mm

After removing the front cover,

press the right and left sides of the

terminal cover in direction 1 and

lift the terminal cover in direction

NOTE