Instruction manual

4. Wiring

Open the front cover and verify that the strip length is 5.5 mm.

 Wiring Inspection

After completing wiring, check the following.

• Wiring is proper.

• Wire clippings or screws are not left in the Inverter.

• Screws are securely tightened.

• Bare wires in the terminals do not contact other terminals.

If the power supply is turned ON during the FWD (or

REV) RUN command is given, the motor will start

automatically.

Turn the power supply ON after verifying that the

RUN signal is OFF.

Failure to observe this warning may result in injury.

1. If the FWD (or REV) RUN command is given when the

RUN command from the control circuit terminal is

selected (n003 = 1), the motor will start automatically

after the main circuit input power supply is turned ON.

2. To set the 3-wire sequence, set terminal S3 (n052) to 0.

5.5mm

CONTACT OUTPUT

SW1

SW2

Scale

WARNING

NOTE