Product Card
10
3. Enter the IP address 192.168.0.xxx, where xxx should be unused address, such as 1, 2, 3, up to 254.
You should not use 0 and 255.
4. Enter the Subnet Mask 255.255.255.0
5. Click on “Gateway”, add the gateway address. If you don’t have a gateway, then skip steps 6 and 7.
Proceed with step 8.
6. Click on DNS Configuration tab, Enable DNS, Enter "hostxxx", xxx should be the same as the IP
address in step 3.
7. In "DNS Server Search Order" add the gateway address.
8. Click on Advanced tab; “Set this protocol to be the default protocol”.
9. Click Ok.
10. Restart when prompted.
11. After restart. You need to make sure that you have correct settings. Go to “Start”, “Run…”, type
“winipcfg”. Select “WL2400 (IEEE802.11)". Click on “More Info>>”, you should have the following
settings:
IP Address 192.168.0.xxx
Subnet Mask 255.255.255.0
Default Gateway The gateway address
entered or empty
DNS Servers The gateway address
entered or empty
12. If one is missing, it means that you did not press “Add” in one of the steps above.
3.4 System testing under Windows 95/98:
1. You need to setup file and printer sharing for Windows 95/98. You must use the same group name, and
the same default protocol. Also, client for Microsoft Networks and File & Printer sharing must be
installed and enabled.
To enable file and printer sharing under Windows, follow these steps:
1. Double-click on the Network icon from the Control Panel.
2. Add “Client for Microsoft Networks” if it is not already listed.
3. Enable file and print sharing by clicking on “File and Print sharing…”.
4. Click on the “Identification” tab.
5. Type a unique computer name.
6. The workgroup must be the same in all computers.
7. Open “Windows Explorer”, right click on any folder or the “C:” drive that you want to share.
8. Click on “Sharing…”, specify a share name, and the access type desired.
9. Click OK.
10. Restart your computer.
2. You should install the TCP/IP protocol if you did not do so already, and perform the procedure under
section 3.3.4 “Manual TCP/IP configuration”. You don’t have to set a gateway address, or enable DNS
at this time, but you can.