User Manual

8
Table C - AMP2440P Typical Installation
TYPICAL INSTALLATION DETAILS
If the customer does the installation, YDI will provide:
Antenna, pole mounted amp, DC injector, DC power supply and
the Model 2400 radio modem, if ordered.
The radio installer should provide:
Mast, cable from antenna to amp, transmission line from the amp to the
DC injector, short cable from the DC injector to the radio modem and
the RS232 cable. However, YDI can also provide any of the cables,
if desired.
DC POWER
INJECTOR
Model 2400
Radio Modem
PC, Router,
PLC, etc.
RS232 cable
Short length of RG58/U
(CAB-RPNM-12
“
)
RF + DC
Choke
110/220 VAC
DC P.S.
N-male
N-male
RP-TNC male
ANTENNA
Omni-directional (shown), or
Grid Dish Yagi Antennas (not shown)
AMP2440
(mounted to mast with U-Bolt)
N-male connector
Transmission Line
LMR-400, Belden 9913 or other low loss cable to radio room
Mast
Drip
Loop
Drawings\diagrams\inst2440.cdr