User Manual

3
IMPORTANT FCC REGULATORY AND SAFETY INFORMATION
The AMP2440P and the YDI WLAN 2400 WLAN cards must be professionally installed.
Table (1) shows the FCC approved antennas that can be used with and without the YDI
AMP2440P. When using the amplifier, only the outdoor antennas listed here can be used.
The amplifier cannot be used with the small indoor patch antenna (Model A24FP06). It is the
responsibility of the installer to ensure that when used in the United States that the
requirements in Section 15.247(b)3iii are meet.
TABLE (1)
Outdoor Antennas Certified for use with the WL2400 and AMP2440P
MODEL DESCRIPTION
Minimum Safe
Uncontrolled Exposure
Distance
A2408 8 dB gain Omni-directional Antenna 20cm
A2412 12 dB gain Omni-directional Antenna 20cm
Y2412 *
12 dB gain Yagi Antenna 20cm
Y2414 *
14 dB gain Yagi Antenna 22cm
A2.45 FP12 *
12 dB gain flat Panel Antenna 20cm
A2.45 FP18 *
18 dB gain flat Panel Antenna 35cm
A2.45 LP17 *
17 dB gain long Panel Antenna 32cm
A2.45 LP15 *
15 dB gain long Panel Antenna 25cm
PT2421 *
21 dB gain Grid Dish Antenna 50cm
PT2424 *
24 dB gain Grid Dish Antenna 70cm
* High-gain directional antennas which can only be used in a point-to-point link with the
amplifier due to ERP restrictions.
Important Safety Information:
Uncontrolled exposure distances is where the power density is 1mW/cm
2
The antennas must be installed
such that there will be no person closer than the specified distances in front of directional antennas or
directly beside the Omni antennas.
4. Amplifier Kit
Each Amplifier Kit Includes:
• Bi-directional Amplifier
• DC Power Injector
• 110/220 VAC Power Supply with 12VDC output
• Stainless Steel U-Bolt and mounting bracket for amp
• Installation Manual