User Manual

6. Amplifier Connections and Indicators

Transmit LED: This LED glows RED in transmit mode indicating that RF power is applied to

the amplifier from the radio.

Receive LED: This LED glows GREEN in the receive mode when DC power is applied to the

amplifier and is off when transmitting.

DC Injector Connection:

This “N” Female connector is connected to the DC Power Injector via the

transmission cable.

Antenna Connection:

This “N” Female connector connects to the antenna with a short length of coax

cable.

7. DC Power Injector Connections and Indicators

A DC Power Injector is an in-line device which “injects” the DC power necessary to operate the amplifier

onto a transmission line. This allows the cable to carry both RF signals and DC power to the mast mounted

amplifier.

Transmit LED:

This LED glows RED when the pole mounted amplifier goes into the

transmit mode. The Remote Transmit LED is driven by unique circuitry,

which actually detects changes in the DC current traveling through the

transmission line to the amplifier.

Receive LED:

This LED glows GREEN when DC power is applied to the amplifier and it is

in the receive mode. When toggling between transmit and receive this LED

will glow slightly dimmer.

To Radio Connection:

This “N” Female connector is connected to the radio modem via a short

jumper cable.

To Amplifier Connection:

This “N” Female connector connects to the amplifier on the mast via the

transmission line.

12 VDC:

This is the DC power input for the injector and is a standard 2.1 mm barrel

jack. +12VDC should be applied with center positive.