Operation Manual

Basic Call Features
103
The active call is placed on hold.
3. Enter the number of the second party and then press , , or the Send soft
key.
4. When the second party answers the call, press the Conf soft key to add the second
party to the conference.
5. Press the Conf soft key to place a new call.
The conference is placed on hold.
6. Enter the number of the new party and then press , , or the Send soft key.
7. When the new party answers the call, press the Conf soft key to add the new party
to the conference.
8. Repeat steps 5 to 7 until you have added all intended parties.
The procedures to set up a network conference call on specific servers may be different
from introduced above. Contact your system administrator for more information.
You can use call park feature to place a call on hold, and then retrieve the call from
another phone in the system (for example, a phone in another office or conference
room). You can park an active call by pressing the Park soft key or call park key (if
configured) on the phone. If the call is parked successfully, there is a voice prompt
confirming that the call was parked. You can retrieve the parked call by pressing the
Retrieve soft key or the retrieve park key (if configured). If the parked call is not
retrieved within a period of time defined by the system, the phone performing call park
will receive a call back.
Note
The IP phone supports call park feature under the following modes:
 FAC mode (dial the call park code to park the call to local extension or a desired
extension)
 Transfer mode (park the call to directional parking lot directly)
Call park is not available on all servers. Contact your system administrator for more
information.