Specifications

User Guide for the SIP-T46G IP Phone
88
 Using the speakerphone
 Using the headset
You can also dial the number first, and then choose the way you want to speak to the
other party.
You can also search and dial a contact from call history, local directory or remote phone
book. For more information, refer to Contact Management on page 34 and Call History
Management on page 53.
During a call, you can alternate between Speakerphone, Headset, and Handset modes
by pressing the Speakerphone key, the HEADSET key, or by picking up the handset.
The call duration of the active call is visible on the LCD screen. In the figure below, the
call to the number”1000” has lasted 40 seconds.
To place a call using the handset:
1. Pick up the handset.
2. Enter the desired number using the keypad.
3. Press , , or the Send soft key.
The # key is configured as a send key by default. You can also set the * key as the send
key, or set neither. For more information, refer to the Key as Send on page 27.
Note
To place a call using the hands-free speakerphone mode:
Do one of the following:
- With the handset on-hook, press or the line key to obtain a dial tone.
Enter the desired number using the keypad.
Press , or the Send soft key.
You can also dial using the SIP URI or IP address. To obtain the IP address of a phone,
press the OK key when the phone is idle. The maximum length of SIP URI or IP address
length is 32 characters. For example, SIP URI: [e-mail], IP: 192.168.1.15.
Your phone may not support direct IP dialing. Contact your system administrator for more
information.