User Guide - VCR20
Table Of Contents
- Contents
- About This Guide
- Getting Started
- Calling
- Local Video Conference
- Using the Yealink VC Cloud Management Service Platform
- Using Yealink Meeting Server
- Using the Third-Party Video Conference Platforms
- Content Sharing
- Using WPP20 Wireless Presentation Pod
- Introduction of the WPP20 Whiteboard Note Toolbar
- Introduction of WPP20 Note Toolbar
- Receiving Shared Whiteboard or Content
- Initiating Whiteboard Sharing on WPP20
- Saving the Content or Whiteboard Picture Locally via WPP20
- Saving/Sharing Whiteboard Source Files via WPP20
- Importing the Whiteboard Source File via WPP20
- Importing an Existing Whiteboard during a Call via WPP20
- Configuring Camera Settings
- Local Screen Layout
- Recording Videos and Screenshots
- Basic Settings
| Configuring Camera Settings | 35
Importing the Whiteboard Source File via WPP20
If you want to continue discussing the saved whiteboard file, download it from the cloud disk to your local
system and use WPP20 to import the whiteboard source files.
Procedure
1. At the note toolbar, tap > Import whiteboard.
2. Select the whiteboard file locally and import it.
Importing an Existing Whiteboard during a Call via WPP20
If you have made notes on the whiteboard locally before the call, you can choose to import the whiteboard
to continue the discussion after the call.
Procedure
In the note toolbar, tap > Import whiteboard before talking.
Configuring Camera Settings
• Controlling Local Cameras
• Tracking Mode
• Enabling/Disabling Privacy Protection
• Allowing the Remote System to Control Your Camera
Controlling Local Cameras
If you do not enable the tracking mode feature, you can pan or tilt the camera and adjust the focal length
when you are in a call or on the idle screen.
About this task
If you do, the camera is adjusted automatically and you cannot control it.
• Enabling Manual Camera Control When not in a Call
• Enabling Manual Camera Control When in a Call
• Adjusting Cameras When not in a Call
• Adjusting Cameras When in a Call
Enabling Manual Camera Control When not in a Call
Procedure
1. On the idle screen, go to More > Camera Control.
2. Press OK Key to display more menus and select Tracking Mode.
3. Select Off.