User Guide - VCR20
Table Of Contents
- Contents
- About This Guide
- Getting Started
- Calling
- Local Video Conference
- Using the Yealink VC Cloud Management Service Platform
- Using Yealink Meeting Server
- Using the Third-Party Video Conference Platforms
- Content Sharing
- Using WPP20 Wireless Presentation Pod
- Introduction of the WPP20 Whiteboard Note Toolbar
- Introduction of WPP20 Note Toolbar
- Receiving Shared Whiteboard or Content
- Initiating Whiteboard Sharing on WPP20
- Saving the Content or Whiteboard Picture Locally via WPP20
- Saving/Sharing Whiteboard Source Files via WPP20
- Importing the Whiteboard Source File via WPP20
- Importing an Existing Whiteboard during a Call via WPP20
- Configuring Camera Settings
- Local Screen Layout
- Recording Videos and Screenshots
- Basic Settings
| Local Screen Layout | 37
Enabling/Disabling Privacy Protection
The privacy protection feature can prevent others from viewing your meeting status on the device web user
interface when you are not in a call, which can protect the important information from being stolen if your
colleagues are having meetings in the meeting room. If you disable this feature, you can see the meeting
status from the small window in the bottom-right corner of your display device.
Procedure
1. On the idle screen, go to More > Setting > Basic > Camera.
2. Enable/disable Privacy Protection.
Allowing the Remote System to Control Your Camera
You can allow the remote party to control the angle and the focal length of your camera.
About this task
If you enable the tracking mode feature, the local camera is adjusted automatically and cannot control it.
Procedure
1. On the idle screen, go to More > Setting > Basic > Camera.
2. Enable Far Control Near Camera.
Related tasks
Enabling Manual Camera Control When not in a Call
Enabling Manual Camera Control When in a Call
Local Screen Layout
The local screen layout is only effective for the participants themselves. If you are in a local conference,
the call layout is the local layout. Each participant can adjust their own local layout. If you are in a cloud
conference or a YMS conference, the local layout consists of the conference layout and the local camera
layout. The conference layout can only be set by the moderator, and participants can only set their local
layout.
The system supports the following layouts:
• 1+N: in this layout, the assigned participant is given prominence in the largest pane no matter who is
currently speaking, and other participants are displayed in a strip beside the assigned speaker.
• Selected Speaker: in this layout, the selected participant is displayed in full screen.
• Equal N×N: in this layout, every participant is given equal prominence in equal-sized panes.
• Picture-in-picture: PIP mode only takes effect on the local layout. In a two-way video call, the video of
one end is displayed in a large window, and the video of the other end is reduced to a thumbnail in the
bottom-right corner of the large window. In the YMS/Cloud conference, the large window displays the
conference layout and the small window displays the local video.
• Single Screen Layout
• Dual Screen Layout
• Changing the Local Screen Layout
• Specifying Content to the Secondary Screen