User guide - Base DECT

Call Features
37
2. Press the MUTE key again to unmute the conference.
Ending a Conference Call
You can end the current conference call at any time.
Procedure
1. Press the On-hook key or End.
If any party in the conference ends the call, the other parties remain connected.
Network Conference
If your system administrator has set a network conference feature on your phone, you can initiate a conference with
two or more contacts.
Topics
Setting Up a Network Conference
Inviting another Party into an Active Conference Call
Holding/Resuming a Conference Call
Ending a Conference Call
Setting Up a Network Conference
You can set up a network conference with two or more contacts.
Procedure
1. Place a call to the first party.
2. Select Options > Conference.
The active call is placed on hold.
3. Dial the second party’s number.
4. When the second party answers the call, select Conf. to add the second party to the conference.
5. Select Conf. to place a new call.
The conference call is placed on hold.
6. Enter the number of the new party, and then press the OK key.
7. When the new party answers the call, select Conf. to add the new party to the conference.
8. Repeat steps 5 to 7 until you add all parties.
Note: The procedures for setting up a network conference call on specific servers may be different. Contact your system
administrator for more information.
Inviting another Party into an Active Conference Call
Any party in the conference call can invite other party into an active conference call.
Procedure
1. Select New Call.
2. Enter the desired number and dial out.
3. When the new party answers the call, press Options, and then select Conference.
The new party is joined the conference call.
Holding/Resuming a Conference Call
Any party in the conference call can place himself/herself on hold, but other parties can continue the conference call
normally.