User guide - Base DECT
Table Of Contents
- Table of Contents
- Getting Started
- Registering the Handset
- Call Features
- Placing Calls
- Answering Calls
- Disabling Call Waiting
- Switching Among the Receiver, Handsfree and Headset Modes
- Silencing or Rejecting Incoming Calls
- Ending Calls
- Muting/Unmuting Audio
- Holding and Resuming Calls
- Call Forward
- Transferring Calls
- Conference Calls
- Recording Using an SD Card
- Advanced Call Features
- Directory
- Call History
- Customizing Your Phone
- Audio Settings
- Maintaining Your Phone
- Appendix
Yealink W80 DECT IP Multi-Cell System User Guide
56
Procedure
1. Navigate to OK > Settings > Display > Wallpaper.
2. Press the navigation keys to select the desired image.
3. Press Save.
Setting the Screen Saver
The screen saver is designed to protect your phone screen by filling it with an analog clock.
When the screen saver is enabled, an analog clock will be activated and appear on the phone screen if the handset is
idle for approximately 10 seconds.
It is only applicable to W56H/W53H.
Procedure
1. Navigate to OK > Settings > Display > Screen Saver.
2. Press Change.
Changing the Screen Brightness
For W56H/W53H, the handset backlight in charger or out of charger can be configured independently.
When in charger/out of charger is enabled, the backlight will be turned off after the handset is idle for about 30
minutes when the handset is or not in the charging cradle. When an incoming call arrives, a key is pressed or the hand-
set status changes, the backlight is automatically turned on.
For CP930W, the backlight automatically turns off, when the phone is charging and inactive for a specified time.
Note
When the CP930W is not in charging, its backlight will be turned off after the phone is inactive for about 30 seconds.
Procedure
1. Navigate to OK > Settings > Display > Display Backlight.
On the CP930W, navigate to Menu > Settings > Basic Settings > Display > Display Backlight.
2. On the W56H/W53H, select the desired value from the In Charger or Out Of Charger field.
3. Select Save.
Setting the Keypad Light
You can enable the keypad light to illuminate the keypad keys when any key is pressed.
It is only applicable to W56H/W53H.
Procedure
1. Navigate to OK > Settings > Display > Keypad LED.
2. Press Change.
Changing the Language
Your phone supports several languages that you can choose to use on the phone.
Contact your system administrator to find out exactly which languages are supported on your phone.