SIP-T40G - User Manual
Table Of Contents
- About This Guide
- In This Guide
- Summary of Changes
- Changes for Release 81, Guide Version 81.20
- Changes for Release 81, Guide Version 81.15
- Changes for Release 81, Guide Version 81.5
- Changes for Release 80, Guide Version 80.95
- Changes for Release 80, Guide Version 80.80
- Changes for Release 80, Guide Version 80.60
- Changes for Release 80, Guide Version 80.20
- Changes for Release 80, Guide Version 80.10
- Changes for Release 73, Guide Version 73.16
- Changes for Release 72, Guide Version 72.2
- Changes for Release 72, Guide Version 72.1
- Changes for Release 71, Guide Version 71.180
- Changes for Release 71, Guide Version 71.150
- Table of Contents
- Overview
- Getting Started
- Packaging Contents
- Phone Installation
- Network Connection
- Phone Initialization
- Phone Status
- Basic Network Settings
- Wireless Network Settings
- Registration
- Idle Screen
- Entering Data and Editing Fields
- Customizing Your Phone
- General Settings
- Audio Settings
- Contact Management
- Call History Management
- Search Source List in Dialing
- System Customizations
- Basic Call Features
- Advanced Phone Features
- Regulatory Notices
- Appendix
- Index
Customizing Your Phone
85
To enable dual headset via web user interface:
1. Click on Features->General Information.
2. Select Enabled from the pull-down list of Dual Headset.
3. Click Confirm to accept the change.
Note
Bluetooth Headset
The SIP-T46G IP phone supports Bluetooth. Bluetooth enables low-bandwidth wireless
connections within a range of 10 meters (32 feet). The best performance is in the 1 to 2 meter (3
to 6 feet) range.
You can activate/deactivate the Bluetooth mode on the phone, and then pair and connect the
Bluetooth headset with your phone. You can pair up to 30 Bluetooth headsets with your phone.
However, only one headset can be connected at a time. You can also disconnect and delete your
Bluetooth headset from the phone.
Note
Dual headset is configurable via web user interface only.
Ensure that the Bluetooth USB dongle is properly connected to the USB port at the back of the IP
phone. For more information, refer to Phone Installation on page 20.