SIP-T40G - User Manual
Table Of Contents
- About This Guide
- In This Guide
- Summary of Changes
- Changes for Release 81, Guide Version 81.20
- Changes for Release 81, Guide Version 81.15
- Changes for Release 81, Guide Version 81.5
- Changes for Release 80, Guide Version 80.95
- Changes for Release 80, Guide Version 80.80
- Changes for Release 80, Guide Version 80.60
- Changes for Release 80, Guide Version 80.20
- Changes for Release 80, Guide Version 80.10
- Changes for Release 73, Guide Version 73.16
- Changes for Release 72, Guide Version 72.2
- Changes for Release 72, Guide Version 72.1
- Changes for Release 71, Guide Version 71.180
- Changes for Release 71, Guide Version 71.150
- Table of Contents
- Overview
- Getting Started
- Packaging Contents
- Phone Installation
- Network Connection
- Phone Initialization
- Phone Status
- Basic Network Settings
- Wireless Network Settings
- Registration
- Idle Screen
- Entering Data and Editing Fields
- Customizing Your Phone
- General Settings
- Audio Settings
- Contact Management
- Call History Management
- Search Source List in Dialing
- System Customizations
- Basic Call Features
- Advanced Phone Features
- Regulatory Notices
- Appendix
- Index
User Guide for the SIP-T46G IP Phone
146
To perform an attended transfer:
1. Press or the Transfer soft key during a call.
2. Do one of the following:
- Enter the number you want to transfer the call to.
Press or to dial out.
- Press the Directory soft key, and then select Local Directory. Select the desired
group and search for the contact (Directory should be configured in advance. Refer to
Directory on page 61 for more information).
Press , or the Send soft key to dial out.
- Press the Directory soft key, and then select History. Select the desired list and then
press or to select the entry (Directory should be configured in advance.
Refer to Directory on page 61 for more information).
Press , or the Send soft key to dial out.
- Press the Directory soft key, and then select Remote Phone Book. Select the desired
group and search for the contact (Directory should be configured in advance. Refer to
Directory on page 61 and Remote Phone Book on page 77 for more information).
Press , or the Send soft key to dial out.
3. After the party answers the call, press or the Transfer soft key to complete the
transfer.
If you are using a handset, the transfer can be completed by hanging up the handset.
You can cancel the transfer before the call is connected by pressing the Cancel soft key.
Call Waiting
You can enable or disable call waiting on the phone. If call waiting is enabled, you can receive
another call while there is already an active call on the phone. Otherwise, another incoming call
is automatically rejected by the phone with a busy message when there is an active call on the
phone. You can also enable or disable the phone to play a warning tone when receiving another
call.
To configure call waiting via phone user interface:
1. Press Menu->Features->Call Waiting.
2. Press or , or the Switch soft key to select Enabled from the Call Waiting field.
3. Press or , or the Switch soft key to select Enabled from the Play Tone field.
4. (Optional.) Enter the call waiting on code or off code respectively in the On Code or Off
Code field.