SIP-T40G - User Manual
Table Of Contents
- About This Guide
- In This Guide
- Summary of Changes
- Changes for Release 81, Guide Version 81.20
- Changes for Release 81, Guide Version 81.15
- Changes for Release 81, Guide Version 81.5
- Changes for Release 80, Guide Version 80.95
- Changes for Release 80, Guide Version 80.80
- Changes for Release 80, Guide Version 80.60
- Changes for Release 80, Guide Version 80.20
- Changes for Release 80, Guide Version 80.10
- Changes for Release 73, Guide Version 73.16
- Changes for Release 72, Guide Version 72.2
- Changes for Release 72, Guide Version 72.1
- Changes for Release 71, Guide Version 71.180
- Changes for Release 71, Guide Version 71.150
- Table of Contents
- Overview
- Getting Started
- Packaging Contents
- Phone Installation
- Network Connection
- Phone Initialization
- Phone Status
- Basic Network Settings
- Wireless Network Settings
- Registration
- Idle Screen
- Entering Data and Editing Fields
- Customizing Your Phone
- General Settings
- Audio Settings
- Contact Management
- Call History Management
- Search Source List in Dialing
- System Customizations
- Basic Call Features
- Advanced Phone Features
- Regulatory Notices
- Appendix
- Index
Advanced Phone Features
189
Receiving RTP Stream
You can configure the phone to receive a Real Time Transport Protocol (RTP) stream from the
pre-configured multicast address(es) without involving SIP signaling. You can specify up to 31
multicast addresses that the phone listens to on the network.
Note
How the phone handles incoming multicast paging calls depends on Paging Barge and Paging
Priority Active parameters configured via web user interface.
Paging Barge
The paging barge parameter defines the priority of the voice call in progress. If the priority of an
incoming multicast paging call is lower than that of the active call, it will be ignored
automatically. If Disabled is selected from the pull-down list of Paging Barge, the voice call in
progress will take precedence over all incoming multicast paging calls. Valid values in the
Paging Barge field:
1 to 31: Define the priority of the active call, 1 with the highest priority, 31 with the lowest.
Disabled: The voice call in progress will take precedence over all incoming paging calls.
Paging Priority Active
The paging priority active parameter decides how the phone handles incoming multicast paging
calls when there is already a multicast paging call on the phone. If enabled, the phone will
ignore incoming multicast paging calls with lower priorities, otherwise, the phone will answer
incoming multicast paging calls automatically and place the previous multicast paging call on
hold. If disabled, the phone will automatically ignore all incoming multicast paging calls.
To configure multicast listening addresses via web user interface:
1. Click on Directory->Multicast IP.
2. Select the desired value from the pull-down list of Paging Barge.
3. Select the desired value from the pull-down list of Paging Priority Active.
4. Enter the multicast IP address(es) and port number (e.g., 224.5.6.20:10008) which the phone
listens to for incoming RTP multicast in the Listening Address field.
5. (Optional.) Enter the label in the Label field.
Label will appear on the LCD screen when receiving the multicast RTP stream.
6. Select the desired channel to listen from the pull-down list of Channel.
RTP stream is listened in the speakerphone mode by default. If you want to listen the RTP
stream using the engaged audio device (speakerphone, handset or headset), contact your
system administrator for more information.
Fixed volume to play RTP stream for specified paging group is configurable by your system
administrator.