SIP-T40G - User Manual
Table Of Contents
- About This Guide
- In This Guide
- Summary of Changes
- Changes for Release 81, Guide Version 81.20
- Changes for Release 81, Guide Version 81.15
- Changes for Release 81, Guide Version 81.5
- Changes for Release 80, Guide Version 80.95
- Changes for Release 80, Guide Version 80.80
- Changes for Release 80, Guide Version 80.60
- Changes for Release 80, Guide Version 80.20
- Changes for Release 80, Guide Version 80.10
- Changes for Release 73, Guide Version 73.16
- Changes for Release 72, Guide Version 72.2
- Changes for Release 72, Guide Version 72.1
- Changes for Release 71, Guide Version 71.180
- Changes for Release 71, Guide Version 71.150
- Table of Contents
- Overview
- Getting Started
- Packaging Contents
- Phone Installation
- Network Connection
- Phone Initialization
- Phone Status
- Basic Network Settings
- Wireless Network Settings
- Registration
- Idle Screen
- Entering Data and Editing Fields
- Customizing Your Phone
- General Settings
- Audio Settings
- Contact Management
- Call History Management
- Search Source List in Dialing
- System Customizations
- Basic Call Features
- Advanced Phone Features
- Regulatory Notices
- Appendix
- Index
User Guide for the SIP-T46G IP Phone
28
5. Press the Save soft key to accept the change or the Back soft key to cancel.
You can configure a static IPv6 address for the IP phone. Before configuring it, make sure that
the IP mode is configured as IPv6 or IPv4 & IPv6.
To configure a static IPv6 address via phone user interface:
1. Press Menu->Advanced (default password: admin) ->Network->WAN Port
2. Press or to select IPv6 and then press the Enter soft key.
3. Press or , or the Switch soft key to select the Static IP from the Type field.
4. Enter the desired value in the IP Address, IPv6 IP Prefix, Default Gateway, Pri.DNS and
Sec.DNS field respectively.
5. Press the Save soft key to accept the change or the Back soft key to cancel.
Note
Wireless Network Settings
Wi-Fi is a popular wireless networking technology that uses radio waves to provide wireless
high-speed Internet and network connections. You can activate/deactivate the Wi-Fi mode on
the IP phone, and then connect your phone to the desired wireless network.
Note
The wrong network settings may result in inaccessibility of your phone and may also have an
impact on your network performance. For more information on these parameters, contact your
system administrator.
Ensure that the Wi-Fi USB Dongle WF40 is properly connected to the USB port at the back of the
IP phone. For more information, refer to Phone Installation on page 20.