SIP-T40G - User Manual
Table Of Contents
- About This Guide
- In This Guide
- Summary of Changes
- Changes for Release 81, Guide Version 81.20
- Changes for Release 81, Guide Version 81.15
- Changes for Release 81, Guide Version 81.5
- Changes for Release 80, Guide Version 80.95
- Changes for Release 80, Guide Version 80.80
- Changes for Release 80, Guide Version 80.60
- Changes for Release 80, Guide Version 80.20
- Changes for Release 80, Guide Version 80.10
- Changes for Release 73, Guide Version 73.16
- Changes for Release 72, Guide Version 72.2
- Changes for Release 72, Guide Version 72.1
- Changes for Release 71, Guide Version 71.180
- Changes for Release 71, Guide Version 71.150
- Table of Contents
- Overview
- Getting Started
- Packaging Contents
- Phone Installation
- Network Connection
- Phone Initialization
- Phone Status
- Basic Network Settings
- Wireless Network Settings
- Registration
- Idle Screen
- Entering Data and Editing Fields
- Customizing Your Phone
- General Settings
- Audio Settings
- Contact Management
- Call History Management
- Search Source List in Dialing
- System Customizations
- Basic Call Features
- Advanced Phone Features
- Regulatory Notices
- Appendix
- Index
Customizing Your Phone
83
System Customizations
Headset Use
If you want to use a wired headset, physically connect your headset to the phone and activate
the headset mode for use. For more information on physically connecting a headset, refer to
Phone Installation on page 20.
If you want to use a wireless headset, insert the Bluetooth USB dongle into the USB port at the
back of the IP phone. For more information on using a Bluetooth headset, refer to Bluetooth on page
85.
This section provides an introduction to wired headset use.
Note
Headset Mode Activation/Deactivation
To activate the headset mode:
1. Press on the phone.
The HEADSET key LED illuminates solid green and the headset icon appears on the idle
screen.
Press the line key or the Answer soft key to answer an incoming call. The call will be
connected to your headset automatically.
Enter the desired number and then press the Send soft key, the phone will then place a call
using the headset automatically. For more information on using the headset to place a call,
refer to Placing Calls on page 117.
To deactivate the headset mode:
1. Press again on the phone.
The HEADSET key LED goes out and the headset icon disappears from the idle screen.
Headset Prior
You can use headset in priority when headset prior feature is enabled. This feature is especially
useful for permanent or full-time headset users.
If both a Bluetooth headset and a wired headset are connected, only the Bluetooth headset can
be used.
To use headset, make sure the headset mode is enabled. Contact your system administrator
for more information.