System information

NeoGate TE100 Administrator Guide
www.yeastar.com Page 21
5.3.4 Reset and Reboot
Figure 5-14
·Reboot System
Warning: Rebooting the system will terminate all active calls!
·Reset to Factory Defaults
Warning: A factory reset will erase all configuration data on the system.
Please do not turn off the system until the RUN light begins blinking. Any power
interruption during this time could cause damage to the system.
5.3.5 Firmware Update
Upgrading of the firmware is possible through the Administrator web interface using a
TFTP Server or an HTTP URL.
Enter your TFTP Server IP address and firmware file location, then click start to update
the firmware
Note：
1. If enabled „Reset configuration to Factory Defaults‟, System will restore to factory
default settings.
2. When update the firmware, please don‟t turn off the power. Or the system will get
damaged.
3. More information for the steps to update the firmware, please refer to this link:
http://www.yeastar.com/download/NeoGate_TE100_FirmwareUpgrade_en.pdf