Digital Torque Wrench Quick Start Guide

BEFORE USING THE WRENCH
BATTERY INSTALLATION
 Remove the battery cover.
 Insert two AAA batteries matching the
-/+ polarities of the battery to the battery compartment.
 Put on the battery cover and fasten it tightly according to the following figures.
ATTENTION: When opening the battery cover of the wrench, you can see a viewing
window for the water contact indicator. Through this viewing window, you can check if
the wrench is damaged by water penetration where the water contact indicator turns red.
ATTENTION:
If an external force is applied to the torque wrench during the power-on/re-set or wake up
period, an initial torque offset will exist in the memory.
ACTIVATION DURING SLEEP MODE
 The wrench will auto sleep after about 5 minutes
idle for power saving. Press to wake up the
wrench during sleep mode.
wrench during the sleep mode.
.
RESETTING THE WRENCH
Press together to reset the wrench.
LOW BATTERY VOLTAGE PROTECTION
 If the battery serial voltage is in low voltage status, the wrench will display a battery symbol
and then turn off after a while.