User's Manual

Sub-Tone channel LCD digit will be blinking

Press Up or DOWN to select your desired channel (1~38), and press Enter ( ) button to

confirm it.

To exit from menu, press M button or PTT switch.

Use same method to set up DCS ( ) or DCS Invertor ( ) Sub-Tone Channels

6.8.1 VOX Function On/Off selection:

Press Menu (P) button for more than 1 second and the radio will enter into function setting mode.

Press Menu (P) button again. Then VOX setting Icons will be blinking.

By pressing UP (▲) or DOWN (▼) button, you can select on or off. To exit from menu, press M

button or PTT switch.

6.8.2 Scan On/Off selection:

Press Menu (P) button for more than 1 second and the radio will enter into function setting mode.

Press Menu (P) button 2 times. Radio will go to Scan setting menu mode.

By pressing UP (▲) or DOWN (▼) button, you can select On or Off.

Select on and press Enter ( ) button to confirm Scan On. To exit from menu, Press M button or PTT

switch

If you want to enable Scan function, Press Menu (P) + Enter ( ) at the same time.

Then radio will begin scan. To stop Scan, press Menu (P) button.

( With programming software, a more selective type of scan method can be chosen.)

6.8.3 Beep Tone On/Off selection:

Press Menu (P) button for more than 1 second and the radio will enter into function setting mode.

Press Menu (P) button 3 times. Radio will go to Beep tone on/off setup mode.