Manual for Series of ESC

♪ ♪ 9kHz
♪ ♪ ♪ 10kHz
♪ ♪ ♪ ♪ 11kHz
♪ ♪ ♪ ♪ ♪ (5) 12kHz
♪ ♪ ♪ ♪ ♪ ♪ (6) 13kHz
♪ ♪ ♪ ♪ ♪ ♪ ♪ (7) 14kHz
♪ ♪ ♪ ♪ ♪ ♪ ♪ ♪ (8) 15kHz
♪ ♪ ♪ ♪ ♪ ♪ ♪ ♪ ♪ (9) 16kHz
Move the stick to full power to select the desired setting (count the beeps) in the submenu.
Acknowledgemen
t: , the setting was saved.
Governor Mode(♪ ♪ ♪ ♪ ♪ )
Move stick into full back position,
♪ Governor mode OFF
♪♪ Governor mode ON
Move the stick to full power after the hearing the desired beeps. Acknowledgement:
, the
setting was saved.
After setting the speed regulation, the ESC will learn the operating speed at the next
start. It is therefore important to wait until you notice a small speed jump indicating
that the regulation has been activated.
If no selection has been made, the above menu options will start over again until a selection is
made.
Note:
The beeps always start with the current setting. This allows the ESC to send a feedback to the
ESC settings.
After the setting of any of these parameters, moving the stick back to full back position will
arm the ESC. Alternatively the ESC can be disconnected and reconnected to allow the setting of
other parameters.