Owner`s manual

ASSEMBLY

Assembly

DOGBONE & SHOCK MOUNTING ASSEMBLY Now insert one double-

row bearing with shoulders facing out to each side of the bottom of

the dogone. Take two M3 x .5 x 12mm pinch bolts and apply Loctite before

fastening down the lower two bearings.

Tip: Do not overtighten the pinch bolts. This will cause pinching and

binding.

DOGBONE & SHOCK MOUNTING ASSEMBLY

Take two M3 x .5 x 12mm

pinch bolts and apply Loctite before fastening down the upper two

bearings.

DOGBONE & SHOCK MOUNTING ASSEMBLY Insert 22mm reducers

into bottom of shock. Use dead blow hammer to pop into place.

REAR TRIANGLE ASSEMBLY Slide a 8.5mm ID washer onto the

31.0mm Ti female. Slide through front of shock and front tabs of

frame.

REAR TRIANGLE ASSEMBLY Tighten down with Ti male bolt and

2.5mm allen key.

THREAD PREP Yeti recommends prepping all bolt threads

at once on your work bench with Loctite or grease. This will

ensure that all bolts are used in assembly. The medium

strength (blue) Loctite formula along with proper torque is

ideal to keep the bolts snug.

DOGBONE & SHOCK SETUP

Insert two double-row bearings with

shoulders facing out into top of dogbone. Make sure bearings are

ﬂush on both sides of dogbone.

Tip: Shoulder is part of bearing that sticks out.

MOUNTING REAR TRIANGLE Attach dogbone to tabs on top tube with

31.0mm Ti female. Tighten down with a Ti male bolt and two 5mm

allen keys.

MOUNTING REAR TRIANGLE

Pull shock and dogbone together.