Owner`s manual

24
Assembly Cont.
ASSEMBLY
Make sure bearings on rear chainstay is flushed with metal of
chainstay. Install seatstay with “Yeti” logo facing out above the
dropout.
Slide a 8.5mm ID washer onto a Ti female 16.5mm and install to
connect the seatstay and chainstay. Slide a 6.5mm ID washer onto a
male bolt and screw into female bolt. Use 5mm key to tighten down.
Tip: Use an elbow 5mm allen key to give more room when tightening down.
Screw male bolt into Ti female stud. Slide a 8.5mm ID washer Ti
female stud.
13
Pull seatstay together with dogbone and shock. Use Fox guide pin to
align everything up. Insert guide pin through junction with dead blow
hammer.
14
MOUNTING REAR TRIANGLE Slide chainstay over indentions. Grease
up main pivot pin (58.5mm long) and align with left finger. Hammer
into place with dead blow hammer.
Using a 6mm and 5mm allen key, use a male bolt to tighten down
male pivot with male bolt. Once you tighten down main pivot, tighten
down pinch bolts on chainstay with 4mm allen key.
11
12
9
10
Double-check pinch bolts on the dogbone and tighten down with
2.5mm allen key. Double-check tightness of all other bolts.
FINISHING TOUCHES Use dead blow hammer to hammer female stud
through. Be ready to catch as it exits the non-drive side of the bike.
Tighten down with 5mm allen keys.
16
15