User's Manual
Page 6 of 18
1.6 Bottom components
Installing the T-flash Memory Card
¾ The T-flash memory card contains the map data required by the PND. It is supplied already
placed into the slot on the side of the PND.
¾ Once the card is installed, it can not be removed during the operation of the device.
¾ If you need to remove the card, switch the unit off first, push the card in and it will eject from
the slot.
¾ When re-installing it can only be inserted one way, with the contacts away from you and the
cut-off corner at the bottom as shown. Slide the card in and push fully so that it locks in
place.
Battery Switch
1. On:Battery is on, the device works normally. Please insure this status when you are using
this device.
2. Off:Battery is off, the device doesn’t work.
2. Accessory Operations
2.1Charging by AC adapter
¾ Before using your PND the battery will need to be fully charged. To maximize the life of the
battery the first charge must be a full charge of the battery.
¾ Plug the mains adapter into the socket on the rear of the unit marked 5V.
¾ Plug the adapter into the main supply.
2.2 Charging by Car Adapter
¾ When using your PND in the car we recommend that you always use the car adapter to power
the unit, especially on long journeys.
¾ Plug the car adapter into the socket marked 5V on the rear of the unit. Plug the other end on
the adapter into the car’s 12V accessory socket.
¾ If possible fix the power cable so that it does not obscure instruments or controls.