Manualshelf

Operating Instructions and Installation Instructions

ManualsBrandsYgnis ManualsAir ConditioningVARMAX TWIN
21222324252627282930
Page 24 / 56 00BNO9132-#
VARMAX TWIN - Installation, Use and Maintenance
4.18.2. Connecting the QAZ36 fl ow sensor
4.18.2.1. Installing the sensor
The sensor must be placed in a pocket as close as possible to the 2
generators' common hydraulic output.
4.18.2.2. Electrical connection
- Connect the QAZ36 fl ow sensor to terminal block BX2 on generator 1's
NAVISTEM B3000 boiler controller (see chapter 8).
!
WARNING:
The sensor cable must be run to generator 1's control panel via the
"low current" tray. Hold the cable using the cable clamps.
5. START-UP (COMMISSIONING)
Refer to the VARMAX generator's installation, use and maintenance manual.
6. CHECKS AFTER COMMISSIONING
Refer to the VARMAX generator's installation, use and maintenance manual.
7. MAINTENANCE OPERATIONS
Refer to the VARMAX generator's installation, use and maintenance manual.
4.18.3. Connection to the boiler controller's terminal blocks
Refer to the NAVISTEM B3000 boiler controller's manual.
OCI345
fi gure 14 - Flow sensor connection
BX2 terminal