User's Manual

2020-01-15
V1.8
R30GB
2019-12-09
新建
2019-11-19
1.最大插卡容量改为128GB
2.RESET键指示部位
3.云台角度向上改67度
4.上墙件外观更新
5.版本号升级
2019-11-25
1.最大插卡容量改为64GB
2.安装APP界面更新
3.版本号升级
2019-12-09
尺寸调整
版本升级
2019-12-13
产品名称更新
版本升级
2019-12-20
安装步骤指示灯黄色改红色
版本升级
2020-01-02
安装界面更新
版本升级
2020-01-15
封面“chooseing”改为
“choosing”
https://docs.google.com/spreadsheets/d/
1R80RkEuIkxga2ITn-83m0TLRj3U-T0cy
G1HmogT064o/edit#gid=462408899
链接文档修改
版本升级
2020-02-17
材质更新为80g书写纸
说明书（国内版）
小蚁云台摄像机1080p 智能版
6099
R30G
385×260mm（平面展开）
PANTONE Cool Gray 11 C+K
80g书写纸
风琴折
正面： 背面：
Installation Hardware x 1
Micro-USB Cable x 1
1
1
Thank you for choosing YI Dome Guard
1. What in the box
YI Dome Guard
Camera x 1
Camera Wall Mount x 1
Power Adapter x 1 User Manual x 1
2. Getting to Know Your Camera
Lens
Indicator Light
Reset Button
MicroSD Card Slot
Light Sensor
Microphone
Speaker
Speaker
R J45 Network
Cable Interface
Power Interface
Input: DC 5V / 1A
3. General Introduction
a) Power on the Camera
As shown in picture , Locate the USB cable on the bottom of
your camera and plug the included micro-USB cable into the
camera. Plug the other end of the micro-USB cable into the
included power adapter. The Indicator Light will turn on to indicate
that the camera is on.
b) Connect Your Camera to the YI Home App
Download and install the YI Home App from the Apple App Store
or Google Play.
You can also scan the QR code of the YI Home App below and
complete the installation.
c) Adding Your Camera to Your YI Account
After logging into the YI Home App, enter the device selection
interface, and select your camera. The camera will flash red and
then click "I heard waiting to connect", once you hear the
"Waiting for connection" voice prompt.
4. Wall Mounting Diagram (optional)
Tips: The mounting wall should be able to support at least 3 times the total weight of
the bracket and the camera.
Use the installation hardware to install the wall
mount to a flat wall/ceiling.
Install the camera onto the wall mount.
Connect the USB power cable to the camera
and switch it on; the camera will automatically
connect to the last configured Wi-Fi network.
Secure the mount with the
included installation hardware
lnstall the device
5. PTZ Angle
Activity angle:
Horizontal: 0° ~ -355°, Vertical: up 67° ~ down 17°
Vertical Roll
Up 67°
Down 17°
Horizontal Roll 355°
Note:
！
R3 0GB V1.8
IC WARNING
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device
The distance between user and products should be no less than 20cm
ADVERTENCIA IC
Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux
RSS (RSS) d'Innovation, Sciences et Développement économique Canada.
Le fonctionnement est soumis aux deux conditions suivantes :
(1) Cet appareil ne doit pas causer d'interférences.
(2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles
de provoquer un fonctionnement indésirable de l'appareil.
La distance entre l'utilisateur et de produits ne devrait pas être inférieure à 20cm.
FCC ID: 2AFIB-YRS3019
IC: 20436-YRS3019
Pairing a device to the camera via a wired connection is not supported. In order
to use a wired connection, you must pair the device the camera to a Wi-Fi
connection and then switch to a wired connection.
- When switching your new network environment, reset your camera, and re-follow
the connection and pairing procedure.
- If you are pairing the camera via sound waves, increase the volume of your
mobile device and keep it close to the camera.
*We recommend that
you insert an 8-128GB
high-speed microSD
card, otherwise your
camera will not be able
to store or view historical
videos as well as other
important functions.
Ensure there is a Wi-Fi network available.
Point the QR code displayed on your phone towards the camera
lens and wait for the camera to scan the QR code. After the QR
code has been scanned, click "Next" and wait until you hear
"Pairing successful".
You can now start using your camera!
Product Name: YI Dome Guard
Model: YRS. 3019
Wi-Fi Standard: 2.4GHz 802.11b/g/n
Power Consumption: 3.5W (Max)
Input: DC 5V / 1A
Operating Temperature: 10~50℃