User's Manual

1-5
10
8
III Configuration of the Wifi Repeater.
The repeater has founctions: repeater , router and Access Point. We describe
the setup as wifi repeater in details. So firstly make sure the mode switch is in
the repeater mode.
There are two ways to set up this device as wifi repeater, with WPS or without
WPS. If you want to setup with WPS button, please make sure that the other
device(that you want to conect with) has also a WPS button.
1. Connect the wifi repeater to your exsiting router by WPS button.(go to
point 2 if your exsiting router does not have WPS)
a. Plug the Wifi repeater into a power outlet near your exsiting router (not too
far away from your router) and wait for the repeater to start up.
b. Press WPS button on your exsiting router (usually press the WPS button
for 3 seconds, consult the manual of your exsiting router).
c. Activate WPS on the Wifi repeater by pressing the WPS button for over 5
seconds.
d. The Wifi repeater will connect to your exsiting router. This will take some
time, please wait at least 2 minutes.
2. Connect the Wifi repeater to your exsiting router without WPS.
a. Plug the Wifi repeater into a power outlet near your exsiting router (not too
far away from your router) and wait for the repeater to start up.
b. The Wifi repeater will need to know to which Wifi network it should be
connected and what the password is. Therefore, it is necessary to set the Wifi.
You will need a network cable. Plug one side of the cable in the Wifi
repeater(LAN port) and plug the other end in your PC. You may need to
temporarily disconnect the existing Internet cable.
c. Enter 192.168.10.1 in your web browser (do not use Google, enter it in the
URL bar).
d. Enter admin in both the name and password field.
e. The following screen will appear. Click on “Repeater Wizard”.
Click on Repeater Wizard
7
6
9
1 POWER LED
2. WAN/LAN LED
3. LAN LED
4. 2.4G Signal LED
5. 5G Signal LED
6. POWER ON/OFF Switch
.
L i n k m y w o r l d
REPEATER
Wi-Fi Range Extender
Dual Band AC
7. RESET Button
8. WPS Button
9. Mode Switch(Repeater mode,Router
mode,AP mode)
10. WiFi Signal Strength Indicator
11. LAN Port
12. WAN/LAN Port
I. Parts of the Wifi Repeater
II. LED Indicators
LED Status
Meaning
2.4G Signal/5G
Signal
POWER
WiFi Signal
Strength Indicator
LED off
LED flashing
LED off
LED on
One LED on
Two LEDs on
Three LEDs on
LED on
LED off
LAN& LAN/WAN
No wifi signal
Transferring data
Power off
Power on
Weak reception, strength
below 25 %
Good reception,strength
50%~75%
Excellent reception,
strength above 75%
Cable connection ok
Cable connection not ok
Model No: JWA-AC2319R
Router Repeater AP
Dual Band Repeater
750
POWER WAN/LAN LAN 2.4G 5G
RESET
ON OFF
WAN
LAN
LAN
12 11