User's Manual

21



Asnotedinthe‘ChargingtheLiPoFlightBattery’sectionofthismanual,youcanchargethebattery

whileit’sinstalledinthehelicopteroryoucanremoveandchargeitseparately(or‘swap’itwitha

sparebatterythat’salreadybeenchargedseparately).ToremovetheLiPoflightbatteryyou’llfirst

needtoremovethecanopy.Carefullypulltheleftandrightendsofthecanopyoffofthemounts

thenslowlyslideitforwardtoexposethebattery,controlunitandwireleads.



IMPORTANTNOTE:TheLEDmountedinthecanopyisnotintendedtoberemoved.Becarefulto

notdamagethewireleadsthatconnecttotheLEDwhenremoving(andinstalling)thecanopy.

Also,youcandisconnectthewireleadsandconnectorfromthecontrolunitentirelyifpreferred

(thoughweDONOTrecommenddisconnectingandreconnectingoftenasitcandamagethe

connectorsand/orcontrolunitovertime).



DisconnecttheLiPoflightbatteryfromthewireleadsandconnectorattachedtothecontrolunit,

thencarefullyremoveitfromthemount(slideitupwardswhilegrippingthesidesofthebattery,DO

NOTpullonthewireleads!).Thebatterycannowbechargedseparatefromthehelicopter.



AftertheLiPobatteryhasbeenfullychargedit’sreadytobeinstalledinthehelicopter.Installthe

batterybyslidingitbackintothemountwiththewireleadsorientedupward.



AND AFTER INSTALLING THE BATTERY IN THE

MOUNT/HELICOPTER YOU MUST BE CAREFUL

TO ENSURE PROPER POLARITY BEFORE

CONNECTING IT TO THE 4‐IN‐1 CONTROL UNIT.

By orienting/aligning the wire leads of the

battery and control uni t so they’re ‘red to red’

and ‘black to black’ you’ll be ableto make the

connection with correct polarity. Also, before

making the connection check to be sure the

ON/OFF switch located on the bottom of the

helicopterissettotheOFFposition.



Also,althoughthe‘MicroA’connectorsare‘keyed’tominimizetheriskofareversepolarity

connection,ifyouforcethemitispossibletomakeconnectionwithincorrect/reverse dpolarity

potentiallycausingdamagetothecontrol

unitand/orbattery.Whentheconnectorsareproperly

alignedforcorrectpolarity,connectingthemshouldrequireonlyaminimalamountofpressureto

achievethelight‘click’thatindicatessecureconnection.



Removin

and Installin

the LiPo Fli

ht Batter