User's Manual

24

 Withthethrottlestickinthelowestpossiblepositionensurethatthestickis

‘centered’lefttorightandthattheright‐handstickis‘centered’lefttorightaswellas

upanddown.DONOTmovethesticksasyouturnthetransmitterontoavoid

changingthepropercenter/neutralpositionsofthecontrols.



IMPORTANTNOTE:Movingthecontrolstickswhileturningthetransmitteroncanchange

thepropercenter/neutralpositionsofthecontrolsmakingitdifficulttocontrolthemodel

andimpossibleto‘trimitout’correctly.Andifyoueverfindthistobethecasethensimply

turnthehelicopteroff,turnthetransmitteroffthenfollowthestepstoproperlyturnon

andinitializethetransmitterandcontrolunit.



 TurnthetransmitteronandconfirmthattheLEDindicator(abovethepowerswitch)

beginstoblinkslowlywhiletheLCDscreenpowerson.



NOTE:Ifthiswillbethefirstflight,orthefirstflightfollowingrepairs,youshould‘center’

therudderchanneltrim.Usethedigitaltrimlevertodeterminethecentertrimpositionby

referencingtheLCDscreen(pleaseseethe‘TransmitterDetails’sectionofthismanualfor

moreinformation).



 Afterthetransmitteristurnedonlocatethepowerswitchonthebottomofthe

helicopterthenslideittothe‘ON’position.TheLEDindicator onthecontrolunit(and

theLEDmountedinthecanopy)willbegintoblink/flashrapidlythenwillblink/flash

slowlybeforechangingtoglowsolidred.



IMPORTANTNOTE:AFTERTURNINGTHEHELICOPTERONIT’SIMPORTANTTONOT

MOVEORROTATEITONCETHEREDLEDONTHECONTROLUNITBEGINSTO

BLINK/FLASHCONFIRMINGTHATTHEINITIALIZATIONPROCESSANDCALIBRATIONOF

THEGYROHASBEGUN.IFYOUDOMOVE/ROTATETHEHELICOPTERTOOMUCHWHILE

THELED

ISBLINKING/FLASHINGITMAYAFFECTINITIALIZATION/CALIBRATIONOFTHE

GYROWHICHCOULDREQUIRESIGNIFICANTRUDDERCHANNELTRIMADJUSTMENTS

AND/ORPREVENTTHEGYROFROMWORKINGDURINGTHEPENDINGFLIGHT.IFTHIS

HAPPENSYOUMUSTTURNTHEHELICOPTEROFFANDREPEATTHE

INITIALIZATION/CALIBRATIONPROCESS.



 WhentheLEDindicatorglowssolidredthecontrolunitisinitializedandreadyfor

flight.Usecautionastheupperandlowerrotorbladeswillnowspinwhenyouraise

theleft‐hand/throttlestick!

