User Manual

YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!

INSTALLATION CLEARANCE REQUIREMENTS-INDOOR UNIT

MAKE SURE OF ENOUGH SPACE FOR INSTALLATION AND MAINTENANCE

To take into consideration the operational convenience and safety in installation, it is recommended to ensure enough

space between the unit and the walls.

Attention: If there are some additional function devices to install on the unit, be sure add to the installation space for the

function devices.

INSTALL THE WALL MOUNTING PLATE

 Prior to installing the mounting plate, check the unit and make sure the unit is in good condition and ready to

install.

 Check to make sure the installation location is strong enough to hold the weight of the whole unit and is in a

location that is convenient to install, maintain, service and close to the outdoor unit.

 Install the indoor unit. Use enough anchor bolts to secure the mounting plates to the wall for indoor units. The

mounting plate should be level and secure and ready to receive the indoor unit.

Install Mounting Plate and Drill Hole for Combination of Copper Line/Wire Cable/Drain Hose

NOTES:

Anchors must be put into the holes, where the solid

arrows are pointing, as shown, to secure the mounting plate

firmly and to hold the weight of the indoor unit. If more

screws/anchors are required, make sure, to keep the two

holes close to each other, at least 2 inches apart.

The mounting plate should be attached to the structural

part of the wall. Minimum clearance, as shown, is required to

ensure proper airflow and allows enough room for easier

service.

Steps to Mount Plate

 Mark all drill positions. At least 4 anchor holes are required, one at each perimeter corner of the plate. These are

needed to secure the plate, where the bold arrows are pointing, as shown in the picture above. Refer to the

specification sheet for unit weight so that enough anchors are installed at the proper locations.

 Pre-drill guiding holes which are marked for anchors or screws on the wall.

 Confirm the position of the holes and finish drilling to the depth required for anchors (NOT for screws).