User's Guide

SMART REMOTE
USER GUIDE
Shutter
Power/Mode
Shortcut
Setting
Charging Port
Lanyard Hole
LAYOUT
Charge Indicator
Status
Indicators
Attach the magnetic charging cable to charging port on
the back of remote. Cell phone USB charger is required.
The charging indicator will turn on When charging and
turn off when battery is fully charged.
BUTTONS
CHARGING
Power on: Press and hold for 1 second to turn on
Power off: Press and hold for 3 seconds to turn off
Switching modes: Press Power button one time, the
cameras will switch to next mode.
During recording , press the Power button to mark a
HiLight tag.
Power /Mode Button
Shutter Button
Press Shutter button to start/stop recording a video
or taking a photo.
Setting Button
When the Setting button is pressed, the camera will
switch among all sub-modes of the current main
mode in turn.
STATUS INDICATION
POWER INDICATION
When powering on, the Status indicators will use to
indicate the power level.
Each indicator represents 25% power, and how many
indicators are on indicates how much power there is.
When the remote battery is almost exhausted, the
Connection Indicator will blink three times for
notification.
Shortcut Button
Press and hold Shortcut button for 3 seconds to set
current sub-mode as Shortcut sub-mode.
After that, press Shortcut button will immediately jump
to this Shortcut sub-mode.
PAIRING CAMERA
If the pairing fails, select Reset Connections in camera’s
settings and conduct the above operations again.
The paired cameras and remote will connect automatically
when they are powered on.
After a long period of power off, the camera may
completely shut down the wireless connection. You need
to remove the camera battery, put it back and turn on the
power to activate the wireless.
To control multiple cameras at the same time, refer to the
“FIRMWARE UPDATE” instructions, enter the Opitons
and turn on the Multiple Cameras Mode.
Press and hold Setting Button for 3 seconds
to enter the pairing mode. All indicators will blink.
Set your camera to pairing mode: Connections>
Connect Device>Remote
Wait for the pairing success notification on the camera.
Press Setting Button to exit pairing mode.
Connection
On：Connected to cameras
Blinking：Searching for cameras
Video
On：Cameras in Video Mode
Blinking：Recording video
Photo
On：Cameras in Photo Mode
Blinking：Taking Photo
Timelapse
On：Cameras in Timelapse Mode
Blinking：Recording Timelapse
More infomation：
WWW.YOCTOP.COM
or send email to
[e-mail]