Operation Manual

YS 1500

3. Remove the burn grate from the rebox. Inspect and clean thoroughly. Make certain

that the combustion holes in the burn grate and the igniter tube in the rebox are

free of debris or ash build up. Visually inspect the air way between the combustion

fan and the rebox to be certain that it is free and clear of ash and debris. (A shop

vacuum works well for ash and debris removal.)

4. Inspect for and remove any grease build up on the bottom of the cooking chamber.

5. Inspect the silicone seal around the rebox, paying particular attention to the seal

above the rebox at the hopper wall. It will be necessary from time to time to reap-

ply high heat silicone such as Permatex 81878 in this area which insures proper

combustion and grill performance.

6. Reinstall the burn grate. Begin by resting the right hand side of the burn grate on

the rebox and then pressing down on the left hand side of the burn grate until fully

seated. When the burn grate is properly seated it rests rmly on the right hand side

of the rebox and ts close to the hopper wall. Finally, check that the igniter assem-

bly is centered in the respective hole in the burn grate.

FIREBOX

BURN

GRATE

BURN GRATE

RIGHT SIDE

FIRE BOX

BURN GRATE

RIGHT SIDE

IGNITER

FIRE BOX

FIG 10

FIG 11