Operation Manual

YS 1500
17
8. Reinstall the cooking grates and second shelf. See FIG 8.
9. Remove, inspect and clean the grease bucket as needed. Reinstall the grease
bucket under the right side of the grill.
10. Open the hopper lid and inspect for any foreign materials.
11. Continue to Startup Procedure.
AUGER
SHIELD
AUGER
SHIELD
7. Reinstall the heat management plate. There are two brackets in the right side of the
cooking chamber, two in the center and an auger shield. This is what the heat man-
agement plate sits on. Take the right side heat management plate and line the bolts
up with the right side and center mounting brackets within the chamber and set in
place. See FIG 12. Take the left heat management plate and line up the bolts with
the middle mounting brackets and the left side will sit on the auger shield. Once in-
stalled check to be certain that the edges are approximately one-quarter inch below
the grate rails. See FIG 13.
FIG 13
RIGHT SIDE
MOUNTING
BRACKETS
CENTER
MOUNTING
BRACKETS
RIGHT SIDE
MOUNTING
BRACKETS
CENTER
MOUNTING
BRACKETS
FIG 12