Operation Manual

YS 1500

If the gap is greater than 3/16” the below steps should be followed.

1. Start by removing the burn grate from the rebox and placing it on its top.

2. Next, step on the burn grate and apply enough pressure to bend it back to its origi-

nal shape. DO NOT apply too much pressure or you will overcorrect the burn grate

and it will not t back into the rebox.

3. Place the burn grate back into the rebox and check the gap between the back

wall and the burn grate to insure a proper t. If a gap still exists then repeat steps

1 and 2.

FIG 24

FIREBOX

BURN

GRATE

FIG 25