User Manual

IM 01E20D01-01E

2-1

2. HANDLING PRECAUTIONS

This instrument has been inspected carefully at the

factory before shipment. When the instrument is

delivered, visually check that no damage has occurred

during transportation.

Read this section carefully as it contains important

information on handling this instrument. Refer to the

relevant sections for information not contained in this

section. If you have any problems or questions, please

contact Yokogawa sales office.

2.1 Checking Model and

Specifications

The model code and specifications are found on the

data plate located on the outside of the case. Check

that the model code and specifications match what you

have ordered.

Be sure you have your model number and serial

number available when contacting Yokogawa.

F0201.EPS

0038

*1)

Figure 2.1.1 Data Plate (Integral Flowmeter Type)

*1) In case of the sizes of 2.5 to 25mm (0.1 to 1.0 in.) ,

“0038” is not described.

F0202.EPS

0038

*1)

Figure 2.1.2 Data Plate (Remote Flowtube Type)

*1) In case of the sizes of 2.5 to 25mm (0.1 to 1.0 in.) ,

“0038” is not described.

In case of the sizes of 500 to 2600mm (20 to

104 in.), CE marking and “0038” are not described.

2.2 Accessories

Check that the parts shown below are included in the

package:

 Remote Flowtube(size 2.5 to 1000 mm(0.1 to 40 in.)):

Centering device (wafer type only): 1 pc.

Hexagonal wrenche: 2 pcs. (one each of 1.5 mm

and 3 mm nominal sizes)

 Integral Flowmeter:

Centering device (wafer type only): 1 pc.

Hexagonal wrenche: 2 pcs. (one each of 1.5 mm

and 3 mm nominal sizes)