User Manual

IM 01E20C02-01E
10-2
10. MAINTENANCE
10.1.2.2 Changing the Display Unit Direction
90 Degrees
(1) Hold the display unit with your hand and remove
the two mounting screws.
(2) Turn the display unit 90 degrees clockwise and
confirm the assembling position, taking care of the
connector and wire of the display unit.
At this time, do not remove the connector.
(3) Secure the display unit using its two mounting
screws.
F1004.EPS
Display unit mounting
screws (two screws)
Clockwise 90°
*1
Figure 10.1.2 Changing the Display Unit Direction 90
Degrees
IMPORTANT
*1: To preserve the safety, do not touch the
electrical circuit and cable of shaded area.
10.1.2.3 Installing the Cover
(1) Taking care not to entangle the cables, install the
cover to the flowmeter by turning it in the direc-
tion of the arrow as shown below.
(2) Tighten cover locking screw 1 counterclockwise
using a hexagonal wrench (nominal size 3) to lock
the cover.
F1005.EPS
Cover locking
screws
Figure 10.1.3 Installing the Display Cover