Instruction Manual

25
SLOW ER NO.
Set contents
Selection
Default
Setting slow error number.
10～50
20
COMPEMC NUM.
Set contents
Selection
Default
Setting compensation number.
Torque is also measured throughout compensation number.
0～5
0
FREERUNNING NG STOP
Set contents
Selection
Default
Setting ON/OFF of free-running NG stop.
ON: In the event of free-running angle NG, the tool stops.
OFF: In the event of free-running angle NG, the tool does not stop.
OFF
ON
OFF
FINAL ANG. NG STOP
Set contents
Selection
Default
Setting ON/OFF of final angle NG stop.
ON: In the event of final angle NG, the tool stop.
OFF: In the event of final angle NG, the tool does not stop.
OFF
ON
OFF
Hand Release
Set contents
Selection
Default
Setting to judge whether OK or NOK in case the tightening in which the throttle
lever was released before shut of is in the OK range.
NG: Judge as NG even if the tightening is in the OK range. (Even SLOW2 is judged
as NG)
OK: Judge as OK if the tightening is in the OK range. (SLOW2 is judged as OK)
NG:
OK:
NG
BOLT NUMBER
Set contents
Selection
Default
Setting bolt number under quantity control.
0～99
2
START REV NO. **Reverse amount at tightening start
Set contents
Selection
Default
The main shaft rotates in the reverse direction for the set rotation amount at tool
start.
0~5.0 (rotation)
0: No reverse rotation at tool
start.
0.0
START REV SPEED **Reverse rotation speed at tool start
Set contents
Selection
Default
Setting reverse rotaton speed at tool start.
300～1200 (rpm)
1200
REVERSE PROHIBIT **Reverse prohibition