User Manual
Table Of Contents
- Service Guarantee
- 1.Introduction
- 1.Installation
- 2.SD Card Slot
- 3.APP Download
- 5.Mobile APP CamHipro Connection
- 5.2 Connect to IP Camera Hot-Spot and then Configu
- 5.3 Add Camera
- 5.4 Wi-Fi Setting
- 5.5 Connect the Camera by Searching Nearby Devices
- 5.6 Mobile APP Function Introduction
- 5.6.1 Micro SD Card Video files playback and downl
- 5.6.2 Local files, device list and add new camera
- 5.6.3 Pre-set point and auto cruise (For PTZ)
- 5.6.4 Change password
- 5.6.5 Set factory default settings of the camera
- 5.6.6 Alarm management and notification
- 5.6.7 Motion Detection
- 5.6.9 FTP setting
- 5.6.10 Video and audio settings
- 5.6.11 SD card plan recording
- 5.6.12 Device time setting
- 5.6.13 SD card setting
- 6.Computer Browsing Access
- 7.Video Management Software (HIP2P Client)
- Frequently Asked Questions
- Check your connecting device:
- 10 -
Step 1 Step 2 Step 3 Step 4
5.5 Connect the Camera by Searching Nearby Devices
A） Connect the camera to the power supply and the camera will start its self-test mode, which
should take about 15 seconds. When finished, Open the ‘CamHipro’ APP.
B） Use Search Nearby Devices follow the below steps.
Note:
1.Please make sure that the camera has been connected to the router’s Wi-Fi.
2.Please make sure that your cell phone is connected to the same Wi-Fi channel as the camera.
3.If there is no camera on the device list, please move closer to the camera and refresh.
Step 1 Step 2 Step 3