User Manual

- 14 -
Auto Cruise Function Setup:
There are 16 different areas which you can set for Auto Cruise. You can choose any number of positions
from 1-16 you want to set up.
Adjust the camera rotation to the first point you want to monitor on the app; input "1" then select Setting;
Adjust the camera rotation to the second point you want to monitor on the app; input "2" then select Setting;
……
until you setup your desired areas up to16 points
……
After you set up your 16 points, input "41" then click transfer(“Call”on the web,”Goto”on HIP2P). The camera
will auto cruise.
Input "41" then click Setting(“Submit”on the web,”set”on HIP2P), auto cruise will stop.
Note: This command pre-set is just one example of the camera command. All functions of the camera use
this method for setup, but different cameras may have different commands, as an example; if you would like
to set the cruise function to P-1 then it should be 41, however, for P2 or P14 etc. it may not be 41, therefore
if you would like to know all the function commands for the camera, pls contact support via email at:
[e-mail]