User Manual
Table Of Contents
- Service Guarantee
- 1.Introduction
- 1.Installation
- 2.SD Card Slot
- 3.APP Download
- 5.Mobile APP CamHipro Connection
- 5.2 Connect to IP Camera Hot-Spot and then Configu
- 5.3 Add Camera
- 5.4 Wi-Fi Setting
- 5.5 Connect the Camera by Searching Nearby Devices
- 5.6 Mobile APP Function Introduction
- 5.6.1 Micro SD Card Video files playback and downl
- 5.6.2 Local files, device list and add new camera
- 5.6.3 Pre-set point and auto cruise (For PTZ)
- 5.6.4 Change password
- 5.6.5 Set factory default settings of the camera
- 5.6.6 Alarm management and notification
- 5.6.7 Motion Detection
- 5.6.9 FTP setting
- 5.6.10 Video and audio settings
- 5.6.11 SD card plan recording
- 5.6.12 Device time setting
- 5.6.13 SD card setting
- 6.Computer Browsing Access
- 7.Video Management Software (HIP2P Client)
- Frequently Asked Questions
- Check your connecting device:
- 24 -
Image: Adjust the brightness, saturation, contrast, exposure parameter and set the WDR, AES, and Img
mode, Intelligent night mode, IR LED Control, IRCut mode in this interface. (The camera does not support
full colour night vision and smart night vision currently.)
Audio: Audio type supported G711 / 726 protocol, audio stream selection on/off, audio input type selection,
input / output volume adjustment
6.5.2 Setting
Network
Network: The IP address can be selected either manually or automatically. The DNS also can be selected
manually or automatically.