User Manual
Table Of Contents
- Service Guarantee
- 1.Introduction
- 1.Installation
- 2.SD Card Slot
- 3.APP Download
- 5.Mobile APP CamHipro Connection
- 5.2 Connect to IP Camera Hot-Spot and then Configu
- 5.3 Add Camera
- 5.4 Wi-Fi Setting
- 5.5 Connect the Camera by Searching Nearby Devices
- 5.6 Mobile APP Function Introduction
- 5.6.1 Micro SD Card Video files playback and downl
- 5.6.2 Local files, device list and add new camera
- 5.6.3 Pre-set point and auto cruise (For PTZ)
- 5.6.4 Change password
- 5.6.5 Set factory default settings of the camera
- 5.6.6 Alarm management and notification
- 5.6.7 Motion Detection
- 5.6.9 FTP setting
- 5.6.10 Video and audio settings
- 5.6.11 SD card plan recording
- 5.6.12 Device time setting
- 5.6.13 SD card setting
- 6.Computer Browsing Access
- 7.Video Management Software (HIP2P Client)
- Frequently Asked Questions
- Check your connecting device:
- 8 -
Step 4 Step 5 Step 6
Step 7 Step 8 Step 9
5.2 Connect to IP Camera Hot-Spot and then Configure Wi-Fi
On your cell phone go to “settings” then select “Wi-Fi”. Your phone should auto search and find the Wi-Fi
signal of the camera.
The name of Wi-Fi Hot-Spot is the UID on the camera example: (Wi-Fi name:IPCAM-900139)
Camera default Wi-Fi Hot-Spot password: 01234567
Note: Only when the mobile phone is approximately 9 – 16 feet away from the camera can the Hot-Spot
signal be detected, when the Hot-Spot is detected, you should then turn off mobile data when the camera is
connected to the camera’s Hot-Spot.