Installation manual

Subject to change without notice. Published in U.S.A. 1083292-UIM-A-0114
Copyright © 2014 by Johnson Controls, Inc. All rights reserved. Supersedes: 1031020-UIM-D-1013
York International Corp.
5005 York Drive
Norman, OK 73069
Other Jumpers
De-humidistat
Heat Pump
Zone Control
Natural Gas LP Gas (Requires LP conversion kit)
LP Conversion Kit Installed By
Supply static after evaporator coil (in w.c.")
Return Static (in w.c.") before filter
Total External Static Pressure
Temperature Rise in Degrees F
Installation debris disposed of and furnace area cleaned up?
Explain operation of system to equipment owner
Blower Speed Selected
Explain the importance of regular filter replacement and equipment maintenance
Gas Side
Air Side: System External Static Pressure (Cooling Mode)
Owner Education
Additional Job Detail
Supply static before evaporator coil (in w.c.")
Calculated input in btuh - clock the gas meter (Nat Gas Only)
Manifold Gas Pressure (in. w.c.") - furnace must be in TEST mode for setupInlet Gas Pressure (in. w.c.")
LP Gas Conversion Kit Part # Used
Burner flame inspected -- flames are blue and extending directly into the primary heat exchanger cells
Return Static (in w.c.") after filter (furnace side)
Air Side: Heating
Air Side: Cooling
Air Side: Continuous Fan
Clean Up
Give owner the owner's manual provided
Gas Type
Explain thermostat use and programming (if applicable) to owner
Cycle Test
Operate the furnace through several heating cycles from the thermostat, noting and correcting any problems
Operate the furnace through continuous fan cycles from the thermostat, noting and correcting any problems
Operate the furnace through cooling cycles (as applicable), noting and correcting any problems
H (High)MH (Med High) ML (Med Low)L (Low)
-10F+10FNOM
L (Low) M (Med) H (High)
YES
NO
NOYES
NOYES
L (Low) ML (Med Low) MH (Med High) H (High)
AB
C
ATR Setting
ADJUST Setting (ECM Models)
COOL Speed Selected
DELAY Setting (ECM Models)