Technical information

107
Installation
No configuration is necessary for the remote terminal to be operative because the terminal operates whatever the control
serial direction might be (can be selected by means of parameter H10). At start-up, the screen will display the control ver-
sion. After 4 seconds, all symbols will be displayed. Should the connection to the RS485 not be correct, or the control unit
is set to OFF, the message offline is displayed.
Info mode
Pressing the up, down and sel keys simultaneously for over 6 seconds, four lines are displayed with information on the
system and communications.

  






















  
 
 



 












Line 1 Terminal version
Line 2 Control unit version
Line 3 Control supervision direction
Line 4 Error percentage between the terminal and the control unit