Specifications

37
Symbol Colour
Meaning
With LED on permanently With LED flashing
1
Amber
Compressor in operation Timing start-up
Compressors under call -
Water pump in operation -
Fans in operation -
Defrost active -
Red Alarm active -
Amber
Cool cycle -
Heat cycle -
Display symbols
The display has three figures in green, plus a symbol and a
decimal. It also shows the symbols, in amber, of the functions
selected (the alarm symbol (-) is red).
Functions of remote control unit buttons
BUTTON UNIT STATUS PRESSING
Prg/mute
Loads values by default Applies voltage when pressed
Return to superior sub-group within programming area until output of
same (except changes in E2PROM)
Simply press
Sel
Access to Direct parameters Press for 5 seconds
Selects a Direct parameter and shows its value / Confirms parameter
changes
Simply press
Prg+Sel
Programming parameters with password Press for 5 seconds
Selects superior parameter within the programming area Simply press or continue
Increase value Simply press or continue
Selects heat function from standby position and vice-versa (P6=1) Press for 5 seconds
Selects lower parameter within programming area Simply press or continue
Lower value Simply press or continue
Selects cool function from standby position and vice-versa (P6=1) Press for 5 seconds
+
Manual alarm reset Press for 5 seconds
Clears hour counters (within programming area) Press for 5 seconds
SEL +
Forced manual defrost Press for 5 seconds






















