Specifications
5
Can also modify operating parameters and monitor the sys-
tem. Can be installed at a maximum distance of 1040 m.
BMS connections
By means of a serial board, it is possible to connect the sys-
tem to a standard RS485 monitoring network.
Low ambient temperature kit (YLHA PLUS 5 to 15)
Includes a pressure transducer for controlling condensing
pressure at low ambient temperature (-18°C).
Standard on models 20 and 27.
High pressure fans
Copper fin coils
Buffer tank
Soft Start
Antivibratory supports
Whenever it is necessary to decrease to a maximum vibra-
tions and noise produced by the unit, a set of rubber an-
tivibratory supports can be used. These should be installed
between the supporting chassis of the unit and the base or
floor where same is to be located. This base must be solid and
dimensioned in accordance with the load it is to withstand.
Use 8/10MA bolts to fasten the supports to the base of the
chassis. The antivibratory support accessory includes 4 parts.
These supports should be spread out and fastened to the
drilled holes at the base of the chiller, the location of which
is detailed in the General Dimensions section.
Units 5 ÷ 15
Units 20 and 27